True Brand SMALL ENGINE TREATMENT WITH PTFE

— Great for Air Tools

Benefits

• Reduced friction and wear       • Easier starting
• Reduced heat and stress         • Improved performance
• Reduced maintenance             • Increased engine life
• Reduced fuel consumption       • Increased resale value
• Protection against corrosive attack during off season storage

True Brand PTFE Treatment Concept

True Brand protects metal-to-metal friction surfaces with fused PTFE treatment, like “wet ice on wet ice,” a substitute wear surface that reduces friction, wear and heat while increasing energy efficiency and prolonging life and trouble-free operation.

• After application, the lubrication system carries True Brand to lubricated friction surfaces.

Now friction components glide by each other on long-lasting
PTFE protection, reducing wear as much as 30 to 90%.

Safe, effective protection

As a manufacturer committed to advanced PTFE treatment technology, True Brand provides PTFE that suspend easily in carrier oils and pass readily through standard filters.

Applications

• Small 2-cycle engines with no crankcase oil sump. (For 2-cycle engines with crankcase oil sump, apply Engine Treatment.)
• Upper-cylinder treatment for all 4-cycle engines and air compressors.

Wherever PTFE treatment with low viscosity oils is needed.

Directions — Small Engine Treatment

Small 2-cycle engines: (Treat outdoors or in well ventilated area.)
Engine must be cool. Remove air filter. Shake, and slowly apply 2 ounces per cylinder thru air intake when engine is first started, running at low speed. Continue to run engine until exhaust smoke clears. Engine is treated and ready for normal use.

• Note: Applying treatment too rapidly may foul spark plug and cause engine to stop. Remove and dry spark plug, reinstall, and apply treatment more slowly and/or run engine at higher RPMs.
• Note: If air intake location on underside of engine makes application difficult, use a short piece of vacuum or windshield washer hose to direct treatment into carburetor air throat.
• Note: True Brand Small Engine Treatment is not designed to be premixed with gas in fuel tank, or with oil in oil injection units.

Upper-cylinder treatment for 4-cycle enginesand air compressors:
Apply through air intake manifold. Use 1 pint per 4 quarts of crankcase oil capacity

Directions — Air Tool Treatment

Shake well before applying.
1. Apply True Brand Air Tool Treatment through air inlet or oil plug.
2. Operate tool immediately to assure proper treatment.
3. Reapply as needed to maintain treatment.

For sluggish air tools: Apply adequate True Brand to free gummed-up vanes or blades, and operate tool. (Repeat if necessary.) True Brand’s treating process frees vanes and blades, and occasional repeat applications keep them free.