RMI-25 protects
your engine
The engines in heavy-duty
trucks and other industrial equipment generate enough heat to melt
down the engine block and related parts. If an engine's cooling system
cannot dissipate that heat because of corrosion or deposit build-up,
serious damage can be done to internal engine parts. Repairing that
damage costs you money - both in expensive repairs and in lost
revenues from downtime.
RMI-25 is a low-cost, effective safeguard against cooling system
failure. It cleans while you drive; inhibits rust, cavitation erosion,
electrolysis and pitting; lubricates water pump seals and thermostats;
and improves cooling. RMI-25 should be at work always in every
water-cooled engine.
Power Flush - While you
drive
RMI-25 and your water pump make an
unparalleled combination for cleaning your entire cooling system.
Vehicle water pumps circulate from 2,500 to 9,000 gallons per hour,
depending on the size or make of your vehicle. By just adding RMI-25
to your radiator, your water pump becomes a powerful cleaner,
circulating thousands of gallons of cleaning solution through your
engine cooling system while you drive.
And this automatic Power Flush requires:
NO draining and flushing
NO downtime, no shoptime, no labor costs
NO loss of antifreeze/coolant
NO 30-to-40-minute engine run time
NO harm to skin or eyes or to the environment
NO coolant gel problems
Just pour some in your radiator and drive away.
Remove 'em all the Easy Way
MINERAL DEPOSITS -- CORROSION -- RUST
THEY'RE THE MAJOR FACTORS IN ENGINE OVERHEATING
Just 1/16 inch of mineral
deposit on 1 inch cast iron is equivalent to 4 1/2 inches of cast
iron, reducing heat dissipation by 40%.
Corrosion deposits of any kind raise the engine operating
temperatures.
A spot of rust raises the temperature inside an engine as much as 700
degrees, causing hot spots and loss of cooling efficiency.
RMI-25 cleans your engine cooling system's metal surfaces, then
protects against cavitation erosion, electrolysis, pitting and further
corrosion. RMI-25 promotes cooler operating and higher efficiency -
and it does it while you drive, with no labor costs.
Antifreeze/Coolant is Only Partial Protection
Everyone knows an engine
needs water and antifreeze/coolant to protect it from freezing and
boil-over.
But worn out antifreeze/coolant can actually damage an engine even
though a hydrometer shows it has plenty of protection left against
freeze-up and boil-over.
Antifreeze requires changing only because the inhibitors against rust
and corrosion dissipate, the "freeze-up" protection doesn't wear out.
RMI-25 extends the life of expensive antifreeze by replacing the
inhibitors - and you still are protected against freeze-up. At the
same time, RMI-25 gives you all the other protection against
cavitation erosion, electrolysis and pitting, as well as lubricating
water pump seals and stabilizing pH.
Treat yourself to savings three ways with RMI-25:
-
Save on the cost of new antifreeze!
-
Save on the cost of hazardous waste disposal!
-
Save 80% on water filter replacements!